error : LibClamAV Error: mpool_malloc(): Attempt to allocate 8388608 bytes.
I am getting the above error on my plesk server and disk is getting filled up within few seconds.
LibClamAV Error: mpool_malloc(): Attempt to allocate 8388608 bytes.
Moderator: Staff
cPanel Server Management
@ 30$ Onwards
@ 30$ Onwards
Re: LibClamAV Error: mpool_malloc(): Attempt to allocate 8388608 bytes.
Hello,
1. Check the current version of clamav installed using the command : rpm -qa | grep clam
2. Install epel-release : yum install epel-release
and then run "yum update clamav"
ClamAV will be updated to latest version.
3. Run freshclam
Now check whether you're still getting the same error.
------------------------------
Martin N
Linux Support Engineer.
Nixtree Solutions
Server Management : https://www.nixtree.com/server-management.php
Follow us on : https://twitter.com/nixtree
1. Check the current version of clamav installed using the command : rpm -qa | grep clam
2. Install epel-release : yum install epel-release
and then run "yum update clamav"
ClamAV will be updated to latest version.
3. Run freshclam
Now check whether you're still getting the same error.
------------------------------
Martin N
Linux Support Engineer.
Nixtree Solutions
Server Management : https://www.nixtree.com/server-management.php
Follow us on : https://twitter.com/nixtree
Re: LibClamAV Error: mpool_malloc(): Attempt to allocate 8388608 bytes.
Hello,
Before doing the above steps make sure there is enough free memory on your server.
------------------------------
Martin N
Linux Support Engineer.
Nixtree Solutions
Server Management : https://www.nixtree.com/server-management.php
Follow us on : https://twitter.com/nixtree
Before doing the above steps make sure there is enough free memory on your server.
------------------------------
Martin N
Linux Support Engineer.
Nixtree Solutions
Server Management : https://www.nixtree.com/server-management.php
Follow us on : https://twitter.com/nixtree